IKIER K1 Pro MAX Guía Para Operar página 46

ENGRAVING PART
01
02
01. Back 02. File Name 03. Status Bar
04. WIFI Name 05. Page Turn Button
06
07
08
09
10
11
12
06. File Name
07. Start
08. Auto Focus: Click the "Start" button, the laser module moves to the center of the screen for automatic focus,
and starts engraving after the focus is completed
09. Preview border: After clicking this button, the laser module will move around the edge according to the size of the engraved pattern
(the cross laser point represents the position of the preview border)
10. Move to center: Click this button, the laser module goes to the center point of the engraved pattern
11. Set bottom left: Set the current position of the laser module as the bottom left initial position
12. Set as center: Set the current position of the laser module as the center point of the pattern
13.14.15.16. Click the top-left button, the laser module goes to the upper left corner of the engraved pattern. Same for other buttons.
17.18.19.20. Control the laser module to move up, down, left and right, long press to move continuously
21. Home: The laser module returns to the origin no matter where it is
22. Coordinate values of X-axis and Y-axis
- 42 -
03 04
05
13 14
18
17 21 19
20
15 16
22
23
24
25
27 26
22. Step size adjustment 23. Completion progress
24. Power adjustment 25. Speed adjustment
27. Pause
Power Adjustment Button
48W: Push the button up, the 48W light is on,
and the laser is at full power at this time
24W: Push the button down, the 24W light is on,
and the laser is only half full power at this time
ENGRAVING PART
22
26. Stop