Cleaning And Care - OK. OCR 100 Manual De Instrucciones

USB mode
14 Connect a USB drive to the USB socket.
1. Select USB mode (USb).
2. The system is scanning the USB drive and starts playing the first song automatically.
3. The playback can be controlled in the same way as for CD player. All basic functions as play/
pause , skipping songs forward
Note: All songs to be played shall be in one folder on USB drive. Music which is saved in subfolders
cannot be played. The order of playing is given by the order of songs in folder.
Note: Connect the USB device directly to the USB port of the unit. Using an extension cable is not
recommended and may cause interference and failure of data transfer. This product supports USB
1.1 and 2.0.
AUX IN mode
15 Connect your music player and the product by audio cable with 3.5 mm-stereo jacks.
1. Once both devices are connected you can start playback at your music player.
2. Use the controls of your external audio device to control the playback.
3. The volume can be controlled by VOL/TUNE on the product.
ALARM SET AND ACTIVATE
16 The alarm can only be activated when the product is switched off, i. e. standby mode:
Alarms 1 and 2
1. Press the ALARM button for approx. 2 seconds and select Alarm 1 (AL 1) or Alarm 2 (AL 2).
2. Press ALARM again, adjust the hours with the VOL/TUNE volume control and press ALARM to
confirm. Set the minutes as well and confirm by pressing the ALARM button. Select the Alarm
signal , CD
pressing the ALARM button. This completes the setting.
3. The setting of Alarm 1 (AL 1) or Alarm 2 (AL 2) is done in the same way.
4. The alarm times Alarm 1 (AL 1) or Alarm 2 (AL 2) can be activated and deactivated by pressing
the ALARM key several times no matter the device is switched on or off.
5. If alarm starts, press the power button

CLEANING AND CARE

• Disconnect the product from the power supply before cleaning it. Clean the product with a soft, damp
cloth and a mild cleaning agent. Finish by wiping it with a dry cloth. Do not use alcohol, acetone,
benzene, scouring cleansers etc. to clean the product. Do not use hard brushes or metal objects.
• Warning! Never immerse electrical parts of the product in water during cleaning or operation. Never
hold the product under running water.
• Warning! When cleaning, never use solvents or abrasive materials, hard brushes, metallic or sharp
objects. Solvents are harmful to human health and can attack plastic parts, while abrasive cleaning
mechanisms and tools may scratch the surface(s).
IM_OCR100_170907_V03_HR.indb 15
15
or
with the VOL/TUNE volume control and confirm again by
or Radio
to turn it off.
are available.
eN
7/9/17 3:04 pm