Idiomas disponibles
Idiomas disponibles
Assembly - Standard Ceiling Mount
1
Preparing for standard mounting
NOTE: The magnet is pre-attached on the canopy
bottom cover for you to remove and install easily.
□
Remove the magnetic canopy bottom cover (FF) from the
canopy (C) by pulling it off.
□
Loosen the two canopy screws (II) located in the bottom of the
mounting bracket (A).
□
Turn the canopy (C) counterclockwise to remove the mounting
bracket (A) from canopy (C).
3
Assembling the fan
WARNING: Failure to properly install the locking pin (DD)
could result in the fan becoming loose and possibly
falling.
□
Loosen, but do not remove, the set screws (JJ) on the
collar (MM) on top of the fan motor assembly (E).
□
Align the holes at the bottom of the ball/downrod
assembly (B) with the holes in the collar (MM) on top of
the fan motor assembly (E).
□
Carefully insert the hanger pin (CC) through the holes
in the collar (MM) and ball/downrod assembly (B). Be
careful not to jam the hanger pin (CC) against the wiring
inside the ball/downrod assembly (B).
□
Insert the locking pin (DD) through the hole near the
end of the hanger pin (CC) until it snaps into its locked
position.
□
Re-tighten the set screws (JJ) on the collar (MM) on top
of the fan motor assembly (E).
2
□
□
□
A
II
C
FF
7
Routing the wires
Route the wires exiting the top of the fan motor assembly (E)
through the decorative motor collar cover (D) and then the
center of the canopy bottom cover (FF).
Make sure the opening of canopy (C) is on top and insert the
ball/downrod assembly (B) through the canopy (C).
Route the wires exiting the top of the fan motor assembly (E)
through the downrod as shown.
MM
CC
Please contact 1-877-592-5233 for further assistance.
C
FF
D
B
E
C
FF
D
B
DD
JJ
E
HOMEDEPOT.COM/HUBSPACE
