Hickory Hardware 1253 Instrucciones

INSTRUCTIONS
CAUTION: Before Installation, check with patio door manufac-
turer for door specifications. Failure to do so may result in glass
breakage!
1. Close sliding door completely.
2. With bolt retracted, place lock in desired position at top or
bottom of leading edge of sliding door, leaving enough room to
clear track so door slides smoothly.
3. Tap back of lock lightly with hammer to mark bolt hole position;
remove lock. Make sure drill will clear glass. Drill 1-1/32" diam-
eter hole for locking bolt.
4. With bolt extended, position lock and slide bolt into hole. Mark
screw holes, remove lock and drill 1/8" diameter holes.
5. Replace lock; install with standard screws and tighten. Or, to
make door tamper-proof, remove standard screws and replace
with non-removable screws.
1253
SATISFACTION GUARANTEED
(See website for details http://www.hickoryhardware.com/warranty)
HICKORY HARDWARE, INC.
©
3438 Briley Park Blvd • Nashville, TN 37269
Made to Hickory Hardware's specifications in China
3.875x5.75_IS.indd 3
Keyed Patio Door
Lock
2/21/07 4:00:49 PM