Idiomas disponibles
Idiomas disponibles
Installation
The adjusting screws are in the end cover on the housing side.
1.
Carefully remove the locking frame (not applicable if "Rotary knob" option is
used).
2.
Move the piston rod a few centimetres away from the targeted limit switch
position.
3.
Adjust the limit switch (+/-).(see Tab. 8 "Setting for adjusting screw 1" and
Tab. 9 "Setting for adjusting screw 2").
4.
Move the drive back to the limit switch.
5.
Repeat the process until the desired dimension is reached.
6.
Secure the locking frame again (not applicable if "Rotary knob" option is
used).
Rotary knob option: The rotary knobs are self-latching and have to be pushed
in direction end cover to make the adjustment. The adjustment must be made
when the knob is pressed in. It is not necessary to remove the end cover when
adjusting the rotary knobs.
Fig. 4
1
2
26
H ousing cover with setting screws (left graphic) or with rotary knobs (right
graphic)
V Setting screw 1 or rotary knob 1 – black
(limit position "piston ejected")
V Setting screw 2 or rotary knob 2 – red
(limit position "piston retracted")
