Idiomas disponibles
Idiomas disponibles
13
Wall Mounted Installation
Due to the many different materials used on different walls, it is highly recommended that you consult your local
builder before you install this appliance on the wall.
A. Select a location that is not prone to moisture and is located at least 36" (914mm) away from combustible
materials such as curtain drapes, furniture, bedding, paper, etc.
B. Have two people hold the appliance against the wall to determine the final location.
C.Place unit face down on a soft, non abrasive surface. Remove the bracket from the back of the unit by removing
the screws, refer to Figure 1.
D.Mark out location, then mount the bracket(s) onto the wall using the supplied screws. This bracket MUST have
the slots facing upward and be level.
NOTE: It is strongly recommended that the mounting bracket (E) be Screwed into the wall studs Where
possible. If the wall Studs cannot be used, ensure that the supplied plastic anchors are used to affix the
bracket to the wall and the bracket is adequately secured.
E. With the wall mounting bracket installed have two people lift the appliance up and insert the hooks on the back
of the appliance into the slots on the bracket and lock back the two screws on both sides.
F. Check the appliance for stability ensuring that the bracket will not pull free from the wall.
Log-set / Crystals Media Installation
A. Glass front must be removed (see below) and the appliance must be mounted in its final location before the
log-set / crystal media installed.
B. If you want your fireplace with log-set, remove the log-set from the package, put it to the fireplace designed
place. Figure 1.
C. CLEAN CRYSTAL or PEBBLE MEDIA: Crystal or pebbles media may have a fine oil residue that needs to be
cleaned prior to installation. Clean the them with mild dish soap, drain, rinse
thoroughly and dry before placing
into the tray.
