Songmics JJC007 Manual página 8

EN
General
Guidelines
Please read the following instruction carefully
and use the product accordingly.
Please keep this manual and hand it over
when you transfer the product.
This summary may not include every detail
of all variations and considered steps. Please
contact us when further information and
help are needed.
Warnings
The product is not intended for children.
Children must be under adult supervision to
use the product. The seller is not liable for
damage or injury.
Never allow children to climb or play around
the product in order to prevent the product
falling and mirror body being broken and to
protect children from personal injury.
During the assembly process, keep small
objects out of the reach of children which
may be fatal if swallowed or inhaled.
08
Notes
The product is primarily used as a dressing mirror and storage cabinet. The user must
assemble and use the product strictly according to the provisions outlined in the manual.
The seller does not assume any responsibility or liability with respect to any damage
caused by incorrect assembly or improper use.
Check if the body of the cabinet is intact and all accessories are complete before a
ssembly. Do not place the edge of the unwrapped cabinet on the floor to avoid chipping
the paint or other damages.
Follow the assembly steps shown in the diagram to position and adjust all parts, and
then gradually tighten all screws. Do not tighten excessively.
Open and close the door lightly, so as not to damage the hinges (opening angle of the
door is approximately 100 degrees).
Place the product on a flat ground and away from sharp and hard objects.
For daily care, clean with a soft and dry cloth. If necessary, you can use a neutral
detergent. It is not allowed to wipe the surface with a wet cloth or abrasive objects.
Keep the product away from acid and alkaline chemicals which may cause a chemical
reaction, discolouration, etc.
Keep this product in a room with normal temperature. Avoid direct sunlight or placing it
next to heat sources which can cause deformation, distortion and possible cracking.
There may be a slight smell of "new" when unwrapping the package. Place the product
in a ventilated area with the cabinet door opened to remove the smell.