Idiomas disponibles
Idiomas disponibles
90553958 JUS500IB REV ALTERNATIEV.qxp:JUS500IB ManualENSP 062408
LED AREA LIGHT
The area light is controlled by the Area Light Power Switch on the front panel of the unit. Make sure the lamp is
turned OFF when the unit is being recharged or stored.
PORTABLE INFLATOR
The built-in 12 volt DC inflator is the ultimate inflator for all vehicle tires, trailer tires and recreational inflatables.
Three different sized nozzles are supplied. Each nozzle will clip on the end of the standard tire valve connector
located at the free end of the inflator hose. The inflator nozzles are stored inside the storage hatch on the top of
the unit. The inflator hose with tire fitting is stored in a retaining channel on the bottom of the unit. The ON/OFF
Switch is located on the front of the unit. The inflator can operate long enough to fill up to 3 average sized tires
before the battery must be recharged.
The inflator may be used by removing the air hose from the storage hatch and if required, fitting an appropriate
nozzle to the air hose. An ON/OFF switch located on the front of the unit controls the power to the inflator and the
gauge light. Refer to the "Controls and Indicators" section on page 5 for locations of inflator hose and nozzle
storage hatch. Return hose to the storage compartment after use.
WARNING: BURST HAZARD
• The inflator is capable of inflating up to 120 pounds per square inch (psi) pressure. To avoid over-inflation,
carefully follow instructions on articles to be inflated. Never exceed recommended pressures. Bursting articles
can cause serious injury.
• Always check pressure with the pressure gauge.
• Never leave the inflator unattended while in use.
CAUTION: RISK OF PROPERTY DAMAGE
Do not operate inflator continuously for extended periods of time (approximately 10 minutes, depending on
ambient temperatures), as it may overheat. In such event, inflator will automatically shut down. Immediately turn
OFF the Inflator Power Switch. Restart after a cooling down period of approximately 10 minutes.
Inflating Tires or Products With Valve Stems
1.Place connector (chuck) on valve stem.
2.Ensure connector is pushed on to valve stem as far as possible before closing thumb latch.
3.Make sure latch is secure.
4.Turn ON the Inflator Power Switch.
5.Check pressure with the pressure gauge.
6.When desired pressure is reached, open thumb latch and remove connector from valve stem.
7.Turn OFF Inflator Power Switch.
8.Allow unit to cool before storing away.
9.Store inflator hose and tire fitting in storage compartment.
Inflating Other Inflatables Without Valve Stems
Inflation of other items requires use of one of the adapters (nozzles).
1.Select the appropriate nozzle, located on the inside back cover.
2.Insert appropriate adapter (i.e. needle) into connector (chuck) and close thumb latch.
3.Small items such as volleyballs, footballs, etc. inflate very rapidly.
4.Insert adapter (i.e., needle) into item to inflate to appropriate pressure.
5.Turn ON the Inflator Power Switch — inflate to desired pressure or fullness.
6.Remove adapter.
7.Switch the Inflator Power Switch OFF.
8.Recharge the unit before storing away.
CARE AND MAINTENANCE
Battery Replacement
It is recommended that the unit be returned to manufacturer for battery replacement. Contact Customer Service,
toll-free, at 1-800-544-6986.
Battery Disposal
Contains a maintenance-free, sealed, non-spillable, lead acid battery, which must be
disposed of properly. Recycling is required — contact your local authority for
information. Failure to comply with local, state and federal regulations can result in fines
or imprisonment. For more information on recycling this battery, call toll-free
1-800-544-6986.
WARNINGS
Do not dispose of this unit in fire as batteries inside this product may explode or leak.
Do not expose the unit containing a battery to fire or intense heat as it may explode.
8
12/18/09
12:21 PM
Page 8
Before disposing of the battery, protect exposed terminals with heavy-duty electrical tape to prevent shorting
(shorting can result in injury or fire).
TROUBLESHOOTING
Problem
Solution
Unit Fails to Jump-Start
• Make sure unit's power switch is in the ON position.
• Check that Jump-Starter has a full charge. Recharge unit if necessary.
• Make sure a proper polarity cable connection has been established.
• Leave charger plugged in and keep unit on charge for 24-48 hours.
• Make sure the USB Charging Port ON/OFF Pushbutton is in the ON
USB Power Port will not power
appliance
position.
• Check that Jump-Starter has a full charge. Recharge unit if necessary.
LED Area Light does not come on
• Make sure the LED Area Light ON/OFF button is in the ON position
• Check that Jump-Starter has a full charge. Recharge unit if necessary.
Portable Inflator will not inflate
• Make sure the Inflator Power Switch is in the ON position.
• Check that Jump-Starter has a full charge. Recharge unit if necessary.
• Make sure connector is pushed to valve stem and thumb latch is
closed when attempting to inflate tires; or nozzle (adapter) is securely
inserted into connector (chuck) on all other inflatables.
ACCESSORIES
Recommended accessories for use with your tool are available from your local dealer or authorized service center.
If you need assistance regarding accessories, please call: 1-800-544-6986.
WARNING: The use of any accessory not recommended for use with this tool could be hazardous.
SERVICE INFORMATION
All Black & Decker Service Centers are staffed with trained personnel to provide customers with efficient and
reliable power tool service. Whether you need technical advice, repair, or genuine factory replacement parts,
contact the Black & Decker location nearest you. To find your local service location, refer to the yellow page
directory under "Tools—Electric" or call: 1-800-544-6986 or visit www.blackanddecker.com.
FULL TWO-YEAR HOME USE WARRANTY
Black & Decker (U.S.) Inc. warrants this product for two years against any defects in material or workmanship.
The defective product will be replaced or repaired at no charge in either of two ways.
The first, which will result in exchanges only, is to return the product to the retailer from whom it was purchased
(provided that the store is a participating retailer). Returns should be made within the time period of the retailer's
policy for exchanges (usually 30 to 90 days after the sale). Proof of purchase may be required. Please check with
the retailer for their specific return policy regarding returns that are beyond the time set for exchanges.
The second option is to take or send the product (prepaid) to a Black & Decker owned or authorized Service
Center for repair or replacement at our option. Proof of purchase may be required. Black & Decker owned and
authorized Service Centers are listed under "Tools-Electric" in the yellow pages of the phone directory and on our
website www.blackanddecker.com.
This warranty does not apply to accessories. This warranty gives you specific legal rights and you may have other
rights which vary from state to state or province to province. Should you have any questions, contact the
manager of your nearest Black & Decker Service Center. This product is not intended for commercial use.
FREE WARNING LABEL REPLACEMENT: If your warning labels become illegible or are missing, call 1-800-544-6986
for a free replacement.
SPECIFICATIONS
Boost Ampere:
Battery Type:
Area Light:
USB Charging Port Output:
Booster Cables:
Imported by
Vector Products Inc.,
701 E. Joppa Rd.
Towson, MD 21286 U.S.A.
500 instantaneous cranking amps
Sealed, high energy density, AGM, lead-acid, rechargeable,
maintenance-free, 12 volt DC
Light Emitting Diode (LED)
5 volts DC 500 mA
#5 AWG cables with 500 Amps heavy duty clamps
9
