Idiomas disponibles
Idiomas disponibles
EN
Before contacting the technicians, please make the
following checks:
Phenomena
Control panel
has no any
display
Inlet hose leaks
It does not
drain water
It does not
inlet water
Spin stops and
begins to inlet
water during spin
program
Press the program
button to select
SPIN, but It does
not spin
The spin is
intermittent when
spin starts
First time to use,
some water flows
from the drain
hose
Notes: If there is still a fault after the above checks, please pull out the plug and contact
the customer service right away, It is dangerous to repair this product by yourself.
Troubleshooting
Possible reason
Plug is not inserted tighty
No electricity in the socket
Power switch is not turned on
Power supply is cut off
Inlet hose connector(connecting
with the tap)is not fxed tightly.
Inlet hose and washing machine
connector is loose
Water outlet of drainpipe is higher
than 1.2m
Drainpipe is bended or get blocked
No water supply
Tap is not open
Inlet hose gets blocked
Too many or too few laundries, or
the machine is not placed stably
Do not close the top lid when drain
is finished
Open up the top lid when starting
drain
Balance the laundries to reach to
the best spin eflect
Water left during factory testing
14
Settlement
Insert the plug tightly
Check the socket or
change to another socket
Press power switch
Check power supply
Install the inlet hose
again Tighten the
connector of the machine
The height of the
drainpipe should be less
than 1.2m Straighten or
clean the drainpipe
Restart when water
supply is resumed
Open the tap
Clean the filter and inlet
gate
The machine is adjusting
automatically
Close the top lid
Close the top lid
Normal
Normal
