Idiomas disponibles
Idiomas disponibles
close the lid. The water level must be within the Min and the Max level. Too little
water will cause the kettle switching off before the water has boiled.
NOTE: Do not fill the water over the maximum level, as water may spill out of
the spout when boiling. Ensure that the lid is firmly in place before plugging the
power outlet.
3. Position the kettle on the power base.
4. Connect the plug into a power outlet. Press down the switch and the indicator
will light up, and then the kettle starts to boil the water. The kettle will switch off
automatically once the water has boiled. If necessary, it will take you 30 seconds
to wait before pressing the switch again to re-boil the water. You may shut off
the power by lifting switch up or directly lift the kettle from the power base at any
moment to stop boiling process.
NOTE: Ensure that switch is free of obstructions and the lid is firmly closed, the
kettle will not turn off if the switch if be constrained or if the lid is opening.
5. Lift the kettle from the power base and then pour the water.
NOTE: Operate carefully when pouring the water from your kettle as boiling
water may result in scald, besides, don't open the lid while the water in the
kettle is hot.
6. The kettle will not re-boil until the switch is pressed again. The kettle may be
stored on the power base when not in use.
NOTE: Always disconnect the power supply when not use.
BOIL-DRY PROTECTION
Should you accidentally let the kettle operate without water, the function of
boil-dry protection will automatically switch off the power. If this occurs, allow the
kettle to cool prior to filling with cold water before re-boiling.
CLEANING AND MAINTENANCE
Always disconnect the appliance from the power outlet and cool it down
completely before cleaning.
1. Never immerse the kettle, power cord or power base in water, or allow
moisture to contact with these parts.
2. Wipe the appearance of body with a damp cloth or cleaner, never use a
poisonous cleaner.
3. Remember to clean the filter at intervals. For easier cleaning, detach the filter
by pressing down the tab of filter inside the kettle and then replace it after
cleaning.
CAUTION: Do not use chemical, steel, wooden or abrasive cleaners to clean the
outside of the kettle to prevent the gloss loss.
4. When not use or storage, the power cord may be wind under the bottom of
kettle.
