Idiomas disponibles
Idiomas disponibles
Installation Instructions – UHBS BY240Z Sensor Remote
Daylight Function Configuration
1.
Press
, the remote LED indicators will show the latest parameters.
DISP
2.
Press
or
to enter setting condition, the parameter LED indicators of remote control will flash to be selected.
3.
Press
, 2 LED indicators will flash in daylight sensor settings, and space press
as setpoint to turn on light automatically, press
4.
Press
to confirm and save all settings.
OK
5.
Aim at the luminaire and press
Light comes on at 100%
when motion is detected.
goes in cycle
at night...
100% on when
motion is detected,
and dims to 10%
after hold-time.
WARNING
• Remove the batteries from compartment if the remote will not be used in 30 days.
3
COOPER LIGHTING SOLUTIONS
to upload the new parameter. The luminaire will flicker ON and OFF once as confirmation.
SEND
Light dims to stand-by
level after the hold-time.
When natural light level
exceeds daylight setpoint,
light will turn off even if
the space is occupied.
IB51944622
Installation instructions
to select daylight
Light remains at low dim
level at night.
The light automatically
turns on at 10% when
natural light is insuffcient
(no motion).
to select daylight
as setpoint to turn off automatically.
Settings on this demonstration:
Hold-time: 30min
setpoint to light on: 50lux
setpoint to light off: 300lux
Stand-by Dim: 10%
Stand-by period: +∞
(when the smart photocell sensor
is open, the stand-by time is only
+∞)
Power On
Off
Check
Every 30min
Dim
No Motion
Motion
100% On
Hold-time ends
