Idiomas disponibles
Idiomas disponibles
For floor mats snap the anchor screws into
the bottom side of the mat into each factory
2
installed retention ring.
Hold the Catch-All firmly in place against the floor and
screw the anchor screw all the way into the floor carpet.
4
Care and Cleaning
1. To remove for cleaning, lift and unsnap the anchor screws one at a time from each retention ring. To re-install, simply snap back into place!
2. Wash with mild soap. Hose off and air dry.
Note: To remove the anchor screws from the factory carpet, clamp onto the snap stud with pliers and turn while lifting gently. Do not attempt to
pull or tear them out, as this will cause damage. To remove any marks, vacuum the area with a brush attachment.
Congratulations
You have purchased one of the many Nifty branded products offered by Lund International, Inc. We take the utmost pride in our products and
want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your product is top quality in terms of fit,
durability and ease of installation.
Place the Catch-Alls in your vehicle and position for best fit (see illustrations "A" and "B").
Illustration A
For Catch-All fronts: Align the part so that it is snug
up against the center tunnel and front foot area.
3
tm
Lund International, Nifty Products Division
2130 Tuley Rd, Hamilton, OH 45015
800-356-5666
Fax 800-782-5448
2004 Lund International, Inc. All rights reserved
c
Nifty and the Nifty logo are trademarks of Lund International, Inc.
tm
tm
Illustration B
Apply the snap covers over all of the snap fasteners.
Press all around the edge of the cap to lock down.
5
Visit us at lundinternational.com
For Catch-All fronts: Make sure that the part is
aligned evenly with the door sill.
