Sauder Steel River Serie Instrucciones De Montaje página 11

Step 6
å
Separate the EXTENSION SLIDES (2) from the EXTENSION RAILS (1) as shown in the upper diagram below. Be
prepared, the parts are greasy.
å
Fasten three EXTENSION RAILS (1) to the RAIL SUPPORTS (EE). Use six 1/2" FLAT HEAD SCREWS (19)
through the holes shown in the enlarged diagram.
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other hole that lines up with the hole in the RAIL SUPPORTS. Turn a
SCREW into this hole.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
1
Push the black lever in and pull the SLIDE from the RAIL.
1
EE
Open end
427851
2
1/2" FLAT HEAD SCREW
(6 used in this step)
A
www.sauder.com/service
1
19
1
EE
7
Open end
F
1
EE
Page 11