Sauder Hammond Serie Instrucciones De Montaje página 10

Step 6
å
Separate the EXTENSION SLIDES (2) from the EXTENSION RAILS (1) as shown in the upper diagram below. Be
prepared, the parts are greasy.
å
Fasten the EXTENSION RAILS (1) to the ENDS (B and C). Use six BLACK 5/8" FLAT HEAD SCREWS (19).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the diagram. Then, slide the inner cartridge of
the EXTENSION RAIL in to find the other holes that line up with the holes in the END. Turn a SCREW into these holes.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
Push the black lever up and
pull the SLIDE from the RAIL.
BLACK 5/8" FLAT HEAD SCREW
(6 used in this step)
Page 10
2
Open end
19
B
1
Open end
www.sauder.com
1
Use these holes.
1
C
Open end
428244