Idiomas disponibles
Idiomas disponibles
Operation Manual
DOOR STOPPER WITH ALARM
Art. No.: 100185
Battery installation:
The door stop alarm requires one 9V battery. When the Low-Battery Indicator illuminates, the battery needs repla-
cing.
1. Toggle the On/Off switch to the 'OFF' position to prevent unintentional triggering.
2. Remove screw on the bottom of the door stop and battery compartment cover.
3. Fit one 9V battery to the connecting leaf, making sure the terminal polarities are correct.
4. Replace cover.
Remove the battery before storing the alarm for extended periods. The battery corrodes over time and may cause
permanent damage to the unit. The depleted battery should be removed from the unit and disposed of properly.
Testing the alarm:
1. Toggle the On/Off switch to 'ON'.
2. Quickly but firmly tap down and release the metal on the cover unit. A quick siren chirp indicates proper operation.
NOTE: The palm of your hand can be used to cover the alarm to reduce risk of hearing damage.
3. Toggle the On/Off switch to 'OFF'
Installation: Insert door wedge at the base of the door as shown in the diagram above, with the pointed edge under
the door gap. The alarm is properly installed if the alarm sounds and the metal contact plate is depressed when the
door is opened. Make sure the non-skid pads on the bottom of the alarm are in firm contact with the floor.
Operation:
1. Toggle the On/Off switch to 'ON' to activate alarm.
2. Toggle the On/Off switch to 'OFF' to deactivate alarm.
Important notice: To clean the unit housing, use a soft cloth slightly dampened with water and wipe dry. Do not use
chemical agents as this may damage and discolor the unit. The device is for indoor use only.
