Idiomas disponibles
Idiomas disponibles
Start Frequency and Stop Frequency
The start frequency and stop frequency set the sweep's upper and lower frequency bounds. The sweep begins at the
start frequency, sweeps to the stop frequency, and then resets back to the start frequency.
– Start and Stop frequencies: 1 μHz to maximum frequency for the waveform. The sweep is phase continuous over
the full frequency range. The default start frequency is 100 Hz. The default stop frequency is 1 kHz.
– To sweep up in frequency, set the start frequency less than the stop frequency. To sweep down in frequency, set
the opposite relationship.
– Sync setting Normal: Sync pulse is high throughout the sweep.
– Sync setting Carrier: Sync pulse has a 50% duty cycle for every waveform cycle.
– Sync setting Marker: Sync pulse goes high at the beginning and goes low at the marker frequency. You can change
this with OUTPut[1|2]:SYNC:MODEMARKER.
Front Panel Operations
Press [Sweep] > Start Freq.
Use the numeric keypad or the knob and arrows to set a desired value. If you use the keypad, select a prefix unit to
finish.
Press Stop Freq.
Use the numeric keypad or the knob and arrows to set a desired value. If you use the keypad, select a prefix unit to
finish.
Keysight EDU33210 Series User's Guide
123
