Idiomas disponibles
Idiomas disponibles
OPErATION
WArNING:
important safety warning and instructions before using this tool.
NOTE:
To conform with uN shipping requirements, lithium-ion batteries are shipped with a partial charge. for
best performance, fully charge the batteries prior to first use. follow charging instructions per this manual.
WArNING:
removal of the battery pack.
NOTE:
BATTeRY and TOOL PROTeCTION feATuReS: Genesis Lithium-ion batteries and tools are designed
with features that protect the lithium-ion cells and maximize battery life. If the tool stops during use, release the
trigger to reset and resume the operation. If the tool still does not work, the battery needs to be recharged.
INSTALLING OR REMOVING THE BATTERY (FIG 4)
• To install the battery pack, insert the battery pack into the bottom of the tool all the way until it locks in
place with a click, as shown in fig 4.
• To remove the battery pack, slide the battery locking tab (5) as shown in fig 4, to release the battery pack,
then remove the battery pack.
CHARGING THE BATTERY (FIG 5)
NOTE:
Always check that the power supply corresponds to the voltage on the ratings plate.
• Connect the charging adaptor (10) and the charging stand (9).
• Plug the adaptor into a 120 Volt AC power source. The GReeN light on the charging stand will illuminate, indicating
the charger is powered.
• Insert the battery (4) all the way into the charging stand until it locks in place with a click, as shown in fig 5. The
ReD light on the stand indicates that the battery is charging.
• The light will turn GReeN after charging is complete.
• To remove the battery from the stand, depress the locking tab (c) on the stand to release the battery pack.
• Batteries may become warm while charging. This is normal.
• If battery is hot after continuous use in the tool, allow it to cool down to room temperature before charging. This
will extend the life of your batteries.
NOTE:
It takes approximately 3-5 hours to charge up a completely discharged battery.
5.
(fig 4)
SWITCH ACTION (FIG 6)
Locate the lock-off switch (2) on the top and the On/Off switch (3) on the bottom of the tool handle.
To Turn On the Tool,
To Turn Off the Tool,
(fig 6)
To reduce the risk of serious personal injuries, read and follow all
Always be sure that the tool is switched off before insertion or
slide the lock-off switch forward, then pull the On/Off switch up.
release both the lock-off and On/Off buttons.
2.
3.
4.
10.
9.
C
(fig 5)
9
