Idiomas disponibles
Idiomas disponibles
1. Please install this product within the voltage
EN
range specified. Failure to do so can cause
electric shock or product malfunction.
2. Electric shocks or product malfunctions may
occur if this product is installed incorrectly.
3. I f s m o ke o r a b u r n i n g s m e l l i s d e t e c t e d ,
disconnect the system immediately.
4. When you install the system, the car should be in
powered off state.
5. Pay attention to the difference on the size of the
hole saw for the sensors. The sensor should not
be installed too tightly or too loose.
6. Do not locate the control unit near to other
interference such as exhaust pipe or other wires.
7. Where the power cable may touch a metal case,
cover the cable with a friction tape. A short circuit
or disconnected wire may cause a fire.
8. Feed as much cable as possible into the vehicle
and clamp it securely. This reduces the possibility
of the cable being hooked or snagged.
9. Keep all cables away from hot or moving parts
and electrical noisy components.
10. The performance may be affected in the following
situations: heavy rain; the gravel road, bumpy
road, sloping road and bush; metal bumper;
very hot, cold or moist weather; the sensors are
covered by snow, ice mud, etc. Other ultrasonic or
electric wave, e.g. the DC/AC switch or 24V/12V
switch may affect the performance of the system.
11. Test the system to make sure it works well before
using.
12. T h i s s y s t e m i s a r e v e r s i n g a i d a n d t h e
manufacturer takes no responsibility for any
accidents caused after the kit is installed.
34
