Idiomas disponibles
Idiomas disponibles
13.
Warning: risk of unsafe
operation. pull starter grip slowly
until resistance is felt. then pull
starter grip (i) rapidly to avoid
kickback and prevent hand or
arm injury.
note: do not allow the starter grip to
snap back. return it gently by hand.
Warning: risk of unsafe opera-
tion. if engine does not start after two
pulls, squeeze trigger of gun to relieve
pump pressure. pull starter cord slowly
until resistance is felt. then pull cord
rapidly to avoid kickback and prevent
hand or arm injury.
note: if the oil level in the engine is
low, the engine will not start. if the
engine does not start, check the oil level
and add oil as needed.
14. as the engine
warms up, move
the choke to the
opeN position.
15. depress trigger
on gun to start
water flow.
Warning: risk of unsafe opera-
tion. stand on a stable surface and
grip gun/spray wand firmly with both
hands. expect the gun to kick when
triggered.
16. release trigger to stop water
flow.
danger: risk of injury from
spray. always engage the trigger lock
when gun is not in use. failure to do
so could cause accidental spraying.
trigger lock engaged
17. adjust nozzle spray for the task
being performed. see how to use
Wand instructions in this section.
shutting doWn
1.
after each use, if you have applied
chemicals, place chemical hose
into container of clean water and
draw clean water through chemical
injection system to rinse system
thoroughly.
caution: risk of property damage.
failure to do so could cause damage
to the pump.
2.
place the engine oN/off switch to
the off position.
3.
place the fuel valve lever (m) in the
off postion.
caution: risk of property damage.
neVer turn the water off with the
engine running.
4.
turn water source off.
5.
pull trigger on spray gun to
relieve any water pressure in hose
or spray gun.
6.
see storage section in this manu-
al for proper storage procedures.
mAINTENANcE
Warning: risk of burn hazard.
When performing maintenance, you
may be exposed to hot surfaces,
water pressure or moving parts that
can cause serious injury or death.
Warning: risk of fire hazard.
always disconnect, spark plug wire,
let the engine cool and release all
water pressure before perform-
ing any maintenance or repair. the
engine contains flammable fuel. do
not smoke or work near open flames
while performing maintenance.
to ensure efficient operation and longer
life of your pressure washer, a routine
maintenance schedule should be pre-
pared and followed. if the pressure
washer is used in unusual conditions,
such as high-temperatures or dusty
conditions, more frequent maintenance
checks will be required.
13 - eNg
N001859
