Idiomas disponibles
Idiomas disponibles
Preparation
1. Remove the
cover (fig. 1).
3. Disconnect the boat from the
accessory box in the direction of
the arrow (fig. 3).
5. Use a Phillips
screwdriver to
open the battery
compartment cover.
Insert 2 x AAA
batteries with the
correct polarity and
replace the battery
compartment cover
(fig. 5).
Charging the mini boat
Insert the USB plug into the USB port on your computer (fig. 7) and
the charging plug into the charging socket on the boat (fig. 8). The
charging LED lights up to indicate the charging is in process. The
charging LED will extinguish after the boat has been completely
charged (charging lasts approximately 15 minutes). Operating time:
approx. 5 minutes.
CAUTION: Insert the rubber plug into the charging socket before putting the boat in the
water (fig. 9). Do NOT operate the boat in the water without ensuring the rubber plug is firmly
inserted into the charging socket. The rubber plug will prevent water from entering into the
electronics and damaging the boat.
Then put the Mini Boat into the water.
2. Disconnect the transmitter
from the accessory box in the
direction of the arrow (fig. 2).
fig. 1
4. Remove the screw on the Mini
Boat base as illustrated (fig. 4).
fig. 3
6. Move the ON/OFF
switch on the remote
controller to ON. The
operation LED lights up
when any button on the
transmitter is pressed
(fig. 6).
Power LED
fig. 5
6
fig. 2
fig. 4
fig. 6
fig. 7
fig. 8
fig. 9
