Tabla de contenido
Batteries
The TREASUREmaster® and TREASUREpro operate for up to 20
hours (without backlight) using two quality "AA" batteries.
1. Open the battery compartment door by gently pushing up
on the battery tabs on the back of the display and hinge open
the battery compartment door.
2. Insert two "AA" batteries, taking note of the correct (+) and
(-) positions marked inside the compartment; close the door
until it snaps shut.
3. High-quality "AA" alkaline batteries are recommended.
Rechargeable NiCad, Nickel Metal Hydride, or other similar
"AA" substitutions work well. Batteries near or above 2 volts per
cell and higher are not recommended.
4. Battery life will change with battery type, operating tem-
perature, and backlight use. Lowering the volume of the built in
speaker or using headphones greatly extends battery life.
Quick Start
1. Press the power ON button. Upon first power up, the detector
defaults to Coin and Jewelry mode.
2. Sweep the search coil from side to side, keeping it level and
close to the ground. Overlap each search pass by at least 50%.
3. Once a target is detected, indicated by a consistent beep,
sweep several passes and note the display identification and
target depth.
4. If the target indicates dig worthy, press the Pinpoint button
( /X). The pinpoint spot is on an imaginary line through the
center of the search coil. It is important to determine where this
detection line begins and ends on the coil, and then use that
"heel" and "toe" to determine target center.
5. Sweep the target area slowly in an "x" pattern. The strongest
beep and shallowest depth indicates target center.
6. Practice with a visible object above ground, moving back
and forth over the target. You can learn to precisely pinpoint a
target's center with this "heel-and-toe" method.
6
Tabla de contenido
