Livoo SL261 Manual De Instrucciones página 10

13. If you use adaptor ( not supplied), only used adaptor with power supply 5V/0.6A
Technical Specifications
Main power supply by USB cable. Product Input: DC 5.0V from adapter of DC 4.5V. Sensor input: 3.0V
Batteries for product : 3 X AAA not included. Batteries for sensor: 2 X AAA n not included
Up to 3 sensors can be connected. Transmission range up to 30 m
Drawing of the device
Figure 1
Time display
1
2 Alarm and snooze icons
Outdoor sensor signal
3
strength
4 Calendar
5 Icons weather forecast
Weekday
6
Moon phase
7
8 Outdoor temperature
and humidity
9 Heat index/Dew point
Channel external sensor
10
How to install batteries AAA
In case of power cut, the batteries will take over.
Open the battery compartment of the product. Insert 3 AAA batteries, matching the correct polarity.
Close the compartment.
Open the battery compartment of the sensor. Insert 2 AAA batteries, matching the polarities. Close the
compartment.
Do not mix old and new batteries. Do not mix alkaline, standard, and/or rechargeable batteries.
Note : When the display unit is powered by battery only, the back light will be off to preserve the
battery. Press the SNZ/LIGHT button to turn the back light on for 10 seconds.
Display Unit Placement
Place the display unit in a dry area free of dirt and dust. Display unit stands up on flat and stable surface.
Important Placement Guidelines
To ensure accurate temperature measurement, place the units out of direct sunlight and away from any
heat sources or vents. The display unit and the outdoor sensor must be within 99ft (30m) of each other.
To maximize wireless range, place the units away from large metallic items, thick walls, metal
surfaces or other objects that may limit wireless communication.
To prevent wireless interference, place both units at least 3ft (1 m) away from electronic devices (TV,
computer, microwave, radio, etc).
Outdoor Sensor Placement
The sensor must be placed outside to observe outdoor conditions. The sensor is water resistant and
designed for general outdoor use. However, to prevent damage, place the sensor in an area which is
protected from the direct weather elements and direct sunshine. The best location is 4 to 8 feet above
the ground with permanent shade and plenty of fresh air to circulate around the sensor.
Outdoor Sensor Function:
press and hold the "CH" button for 3 seconds, display unit will search for a radio signal (RF) from the
outdoor sensor for 3 minutes
The outdoor sensor signal strength will be showed on the display unit. If there are no bars or if bars are
not showing at its maximum strength (4 bars) (3) try placing the outdoor sensor or the display unit
11 Outdoor comfortable level/moldy index
12 Indoor temperature and humidity
13 Indoor temperature alert
14 Tendency indoor temperature
15 Indoor temperature max/min record
16 Indoor comfortable level/moldy index
17 Tendency indoor humidity
18 Display low battery indicator
19 SET button
20 CH button
www.livoo.fr
21 ALERT button
22 DOWN button
23 UP button
24 SNZ/LIGHT button
25 Wall mount hole
26 Battery Compartment 3xAAA
27 External power supply socket
28 Wireless signal indicator
29 Integrated hang hole
30 TX channel selector
31 Batteries Compartment 2xAAA