DIETER'S Peterbilt 388 Instrucciones De Instalación

INSTALLATION INSTRUCTIONS
1. Loosen front fender support bracket until the gap between bracket and fender is sufficient to allow the trim to slide down
into the gap.
2. Slide the front (wider) edge of trim underneath the front fender support bracket. Slide down approximately ½" past edge
of the fender support bracket.
3. Roll the trim over the fender gutter. Ensure that the trim is rolled to match the contour of the fender gutter and that the
side edge is flush against the side of the hood. The back (thinner) edge of the trim should sit flush against, or very close
to rear bottom edge of fender gutter.
4. Adjust the positioning of trim if necessary to achieve ideal fit.
5. When trim is in the ideal position, mark the truck through the hole in trim for later drilling. Also mark a line on the front
edge of trim that corresponds to the edge of the front fender support bracket. This line will serve as a guide for later
installation.
6. Remove trim from truck.
7. Carefully drill Ø3/16" hole through previously marked hole.
8. Remove backing of tape from trim.
9. Slide the front (wider) edge of trim underneath the front fender support bracket, using previously marked line as a guide
for how far to insert the trim.
10. Roll the trim over the fender gutter. Ensure that the trim is rolled to match contour of the fender gutter and that the side
edge is flush against the side of the hood. Also ensure that the tape is secure against the gutter. Continue to roll towards
the back and the hole on the trim should come to line up with the Ø3/16" drilled hole.
11. Remove protective plastic coating from trim.
12. Fasten using supplied hardware and tighten front fender bracket support bracket.
Page 1 of 3
TRIM – FENDER GUTTER STRIPS
Peterbilt 388/389
Driver
Passenger
IIPB022
Front of Truck→
04/2007