Setting The First Remote Control; Automatic Disabling Of The First Remote Control Setting Function; Adjustment Of The Limit Switches; Setting Of The Limit Switches - Cherubini WAVE LOCK RX Instrucciones

SETTING THE FIRST REMOTE CONTROL

This operation can only be performed when the motor is new, or after a total delete of
the memory.
During this step, power up only one motor at time!
T1: First remote control to be set
+
A B
T1
AUTOMATIC DISABLING OF THE FIRST
REMOTE CONTROL SETTING FUNCTION
Every time you connect the power supply to the motor, you have 3 hours to store the
first remote control. After this time, the ability to store the remote control is disabled.
To reset the timer of the function you have to disconnect and reconnect the power
supply to the motor.
Wave Lock RX tubular motors have an electronic limit switch system with an encoder.
This system ensures great reliability and precision in keeping the positions. Limit switch
regulation is performed simply with the remote control. During setting, the motor moves
only as long as the up or down button is pressed, stopping when the button is released. At
the end of setting, press either the up or down button briefly to move the motor.
After setting the remote control, it's necessary to set first the closing position!
For cassette-awnings, hold the button pressed until the motor stops automatically on the
closing position. For open awnings, hold the button pressed and drive until the necessary
closing position.
Notes: - If the awning is completely closed, you have firstly to open it by around 20 cm.
- Because the correct rotation direction will be identified only after the closing
position is set, to close the awning, during setting the closing position, it's
sometimes necessary to use the "down" button.
B

SETTING OF THE LIMIT SWITCHES

SETTING THE CLOSING LIMIT SWITCH

T1
32
B
T1 (2 sec)