Idiomas disponibles
Idiomas disponibles
CHOICE OF THE PROGRAMMING MODES:
RADIO - WHITE WIRE - WHITE WIRE with the radio function active
he Blue Wave RX motor may be programmed using 3 modes:
- RADIO PROGRAMMING: Once the programming has been completed the motor enables
use either by white-wire, by radio, or using both modes (radio/wire).
- WHITE WIRE PROGRAMMING:
· After the adjustment of the limit switches using the white wire, programming remains
active for 5 min. After 5 min have elapsed, the motor must be disconnected from its
power supply and then reconnected in order to reprogram the system.
· If the limit switches are set using the whitewire without programming a remote
control, the radio function is automatically deactivated for programming and for later
use. To reset the radio function, the activation sequence found on this page must be
performed within 5 min from the adjustment of the limit switches (or after having
disconnected and then reconnected the motor from its power supply).
· Once the programming has been completed the motor enables only the use of the
white wire, unless the radio function is reactivated.
- WHITE WIRE PROGRAMMING WITH RADIO FUNCTION ACTIVE: To be able to use both
modes (radio and wire), a remote control must be programmed before the adjustment of
the limit switches in the white wire mode. Once the programming has been completed
the motor enables use either by white wire, by radio, or using both modes (radio/wire).
ACTIVATION/DEACTIVATION OF THE REMOTE CONTROL FUNCTION
To activate/deactivate the remote control function, follow the sequence shown below:
PLEASE NOTE: To deactivate the remote function it is first necessary to totally delete the
remote controls from the memory of the motor (page 38 Blue Wave RX manual).
Activation/deactivation from the CLOSING position:
Activation/deactivation from the OPENING position:
The confirmation movements indicate that the remote control function activation/
deactivation procedure has been successfully carried out.
23
