Idiomas disponibles
Idiomas disponibles
EN
1� Press and hold the SET/OK button (P) on
the touch controls to activate this feature�
The display shows E1 to indicate function
is on�
2� Press and hold the SET/OK button (P)
on the touch controls, then press the
SET- button (J) to deactivate this feature�
The display shows E0 to indicate function
is off�
E0:
Open window detection function off
E1:
Open window detection function on
8.8
Setting timer
1� Press the timer button (S) to activate
timer function� The timer symbol displays
on the display (V) and the hours setting
starts flashing�
2� Press the timer button (S) to skip through
the days until you reach the desired
day for setting� Each day which does
not require timer function should be
programmed as 00.00 for ON and OFF
time for each period�
3� Once the desired day has been selected,
press the increase button (N) or decrease
button (T) to set the ON hours, press the
timer button (S) to continue�
4� Press the increase button (N) or decrease
button (T) to set the ON minutes, press
the timer button (S) to continue�
5� Press the increase button (N) or decrease
button (T) to set the OFF hours, press the
timer button (S) to continue�
6� Press the increase button (N) or decrease
button (T) to set the OFF minutes, press
the timer button (S) to continue�
7� Press the timer button (S) on the
product's touch controls to activate timer
function� The timer function symbol lights
up on the display (D)�
14
NOTICE
» Timer setting can only be done using
touch controls (E)�
» After setting the first period, the timer
moves onto the second period allowing
you to set the time again the same way�
» Repeatedly press SET/OK (P) to scroll
through the days and periods�
» To clear an operational period, set the
ON and OFF times to the same value�
8.9
Changing between Fahrenheit and
Celsius
Press the Celsius/Fahrenheit button (O)
repeatedly until the desired setting has been
selected�
8.10
Changing between logs and
crystals
Change the look of the product by removing
the installed logs (B) behind the display panel
(A)�
1� Remove the display panel (A) as
described in installation B step 1�
2� Continue with the below 2 steps to
remove the screws and logs, then place
the crystals (C) along the display edge
evenly�
1
x 2
