Installing The Shaft - Makita XTU02 Manual De Instrucciones

Installing the shaft

Optional accessory
1. Insert the shaft into the chuck as far as it will go.
2
1
► 1. Shaft 2. Chuck
2. Tighten the chuck by hand, and then place the chuck
key in each of three holes and tighten it clockwise. Be
sure to tighten the chuck key at all three holes evenly.
1
2
► 1. Chuck key 2. Chuck
To remove the shaft, turn the chuck key counterclock-
wise at one of the holes, and then loosen the chuck by
hand.
Installing the mixing blade
Optional accessory
Attach the mixing blade on the top of the shaft, and then
secure it with the hex bolt.
► 1. Mixing blade 2. Shaft 3. Hex bolt
NOTICE:
"UP" mark facing the tool.
► 1. Mark
Hook
Optional accessory
hanging the tool with the hook.
tion or on potentially unstable surface.
3
► 1. Groove 2. Hook 3. Screw
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
1
2
3
8 ENGLISH
Be sure to attach the mixing blade with
1
CAUTION:
Always remove the battery when
CAUTION:
Never hook the tool at high loca-
1
2
1
2
3