Idiomas disponibles
Idiomas disponibles
9. Do not press the device into the fabric as this may damage the fabric.
10. Do not use the device on clothes you are wearing, always take them off. This may
cause personal injury or damage to the lint remover.
11. The device has a protective lock. It will not function unless the blade cover is refitted.
12. Take care not to use the device on buttons, zips, appliqués, patches, stickers, labels,
rips, seams, and seams.
13. Do not use the device on silk, wool, or linen garments. This can damage fabrics and
damage the shaver blades.
14. Do not use the device near water, e.g. in the shower, bathtub, or over a wash basin
with water.
15. Do not allow the device to get wet. Before using the appliance again, it must be
checked by a qualified electrician.
16. Do not handle the device with wet hands.
17. The device should be turned off each time it is put away.
Device description:
1. Battery level indicator
2. Battery charging indicator
3. Working speed indicator
4. Button for changing the working speed / ON OFF power
5. USB type C charging port
6. Blade Cover
7. Blades
8. Rotary shaft
9. Bin for knots and pilling
10. Housing
11. Cleaning brush
12. USB charging cable
BATTERY CHARGING:
To start charging, plug the charging cable (12) into the charging socket (5) and then connect it to the power supply.
When connected to power, the battery charge indicator (2) will illuminate and the battery charge indicator (1) will display the current
battery charge.
When the battery is fully charged, the battery level indicator will show 100%. The time to fully charge the battery is 2-3 hours. When fully
charged, the run time is approximately 120 minutes, depending on the selected speed.
The device should not be used while charging.
USING THE DEVICE
1. Place the garment (fabric) on a flat surface, and smooth out the wrinkles.
2. Switch on the device by pressing the button (4), the device has three speeds. To increase the speed, press button (4) again. Available
speeds: 6500, 7500, 8500 rpm
3. Move the device back and forth across the material.
4. Stubborn knots can be removed by moving the device across and then along ("checkered") on one small piece of clothing.
5. Thin garments can be defrosted by placing them on flat, rigid cardboard.
6. For fabrics with a pattern, move the device in the direction of the pattern.
CLEANING
1. Switch off the device by pressing the button (4).
2. Unscrew the blade protection cover (6) counter clockwise.
3. Remove the blades (7) by pulling them upwards (Caution! The blades are very sharp!).
4. Clean the blade cover (6), the blades (7), and the rotating shaft (8) with the included brush (11).
5. Empty the knots and lint container (9).
6. After cleaning, reassemble all the disassembled parts.
The device has a protective lock. It will not function unless the blade cover (6) is refitted.
TECHNICAL DATA:
Power: 5W
Power supply: USB 5V/1A
4
