Idiomas disponibles
Idiomas disponibles
Using a backpack harness (Sold
Separately) (See Fig. I1, I2, I3)
1. Insert the battery pack into the backpack
harness.
2. Insert the battery adaptor into the trimmer.
3. Connect the backpack harness to your
trimmer with the connecting cord.
More details can be found in backpack harness's
manual.
Cutting Tips
1. Move the trimmer from left to right across the
area to be cut; it is less effective when moving
from right to left.
2. Use the tip of the cutting line to do trimming;
do not force the trimmer head into uncut
grass.
3. Wire and picket fences may cause extra
cutting line wear and breakage. Stone and
brick walls, curbs, and wood may wear cutting
line rapidly.
4. Avoid trees and shrubs. Tree bark, wood
moldings, siding, and fence posts can easily
be damaged by the cutting line.
MAINTENANCE
Always remove the battery pack from
your trimmer after use.
Always check the product prior to being used
for any damage.
Replacing the trimmer head (See Fig. J)
1. Insert the hex key into the hole and rotate
the trimmer head until it stops in a locked
position.
2. Then, rotate clockwise to remove it, and
counterclockwise to assemble it.
Winding the line (See Fig. K1, K2)
1. Insert the replacement line (13 ft or 4 meters)
through the eyelet and feed it through the
other side.
2. Ensure both ends of the line extending out
of the trimmer head are the same length.
Approximately 6ft or 2 meters on each side
of the trimmer head, cut lengths even if
necessary.
3. Turn the dial clockwise to wind the line inside
the spool until about 19cm remains on either
side.
Replace the spool (See Fig. L1, L2, L3,
L4)
1. Take off the cap and remove the old spool.
2. Put the empty spool in and place on the cap
to wind new line in.
Transporting
1. When transporting your trimmer by hand, hold
the middle of shaft to make sure that your
machine is parallel to the ground.
2. When transporting your trimmer in a vehicle,
secure and position it to prevent damage.
Trimmer Line Maintenance
Periodically soak you package of string trimmer
line in a bucket of water for a day or two to
reduce line breakage, wear and line welding.
(twice per season)
Storing
1. Remove the battery pack from the trimmer
before storage.
2. Store the trimmer in a dry and secure place
that is inaccessible to children and other
unauthorized people.
Cleaning
1. Do not use aggressive detergents or solvents.
Clean the machine after use with a moist cloth
dipped in mild detergent.
2. Keep the socket free of foreign matters, and
clean with a soft and dry brush or cloth.
3. Do not spray water onto the motor and
electrical components.
4. Do not use a pressure washer to clean your
machine.
FOR BATTERY TOOLS
The ambient temperature range for the use and
storage of tool and battery is 0℃-45℃ (32℉-
113℉).
The recommended ambient temperature range
for the charging system during charging is 0℃-
40℃ (32℉-104℉).
15
EN
