Cherubini Ocean RX Instrucciones página 28

SETTING THE FIRST REMOTE CONTROL
This operation can only be performed when the motor is new, or after a total delete of
the memory.
During this step, power up only one motor at time!
T1: First remote control to be set
+
A B
T1
REMOTE CONTROL SETTING FUNCTION
Every time you connect the power supply to the motor, you have 3 hours to store the
first remote control. After this time, the ability to store the remote control is disabled.
To reset the timer of the function you have to disconnect and reconnect the power
supply to the motor.
NB: Until the remote control has been memorised, the wired control of the motor
will operate in "dead-man" mode.
ADJUSTEMENT OF THE LIMIT SWITCHES
1. To decide which adjusting screw to fix, simply watch the direction of rotation of the stop
ring nut: if the stop ring nut pulled by the roller goes in direction A, use the adjusting
screw A to set the limit switch in that direction. If it goes to the opposite direction (B),
use the adjusting screw B.
2. Start up the awning or the rolling shutter in the direction in which you wish to set the
first limit switch. After a few turns the motor will stop on the preset stop.
3. Screw the adjusting
screw suited to the
direction (see point
1.) in direction "+" till
it gets to the chosen
position.
4. Invert the engine sense
of direction and set the
second limit switch.
B
AUTOMATIC DISABLING OF THE FIRST
T1
B
T1 (2 sec)