JMA TPX CLONER Manual De Instrucciones página 13

The procedure to connect the cables is:
• Switch on the TPX CLONER by plugging
the power supply (2) into the mains supply
(110/220 Vac) and also into either of the 2
sockets on the back of the cloner.(see pic-
ture 2).
Picture 2 . Back side of the TPX CLONER with the
DC connectors and Serial Comm.
• Connect the serial cable (4) from the TPX
CLONER to the TRS5000.
Picture 3. Second of the three steps to connect
the TPX CLONER to the TRS5000.
• And finally, just plug the DC cable cord
from the free connector of the TPX
CLONER into the TRS5000.
Now you are ready to switch on the TRS5000,
and the third message that will appear on
the display will be TPX CLONER FOUND.
This means that you are ready to work with
Texas Crypto keys.
13