Premier BB-5313USBTB Manual De Instrucciones página 16

CONTROLS ON LED DISPLAY KEY PAD
1. SD/MMC CARD Slot: Insert the SD/MMC card into the SD/MMC card slot, system will automatically
playback song on the memory card inserted. Or, you can press the MODE button until it shows SD on the
LED display to play songs from the already inserted memory card.
2. USB Slot: Insert the USB Flash Drive into the USB slot, system will automatically playback songs on the
USB Flash. Or you can press the MODE button until it show USB on the LED display to play songs from
the already inserted USB Flash.
3. MODE : Press the MODE key until your desired playback source is selected. The cycling sequence of
mode selection is: Blue Connect/LINE/FM/USB,SD
4. PREV/VOL- : During USB/SD playback, short press this button to select previous song, long press to
reduce input source volume. During Radio Channel mode, short press to move to previous pre-
memorized station channel number, long press to reduce volume.
5. PLAY: During USB/SD playback, press this button to pause the playback. Press again to resume playing
and vice versa. During Radio mode, long press this button to initiate memory station search. System will
scan from lowest FM frequency to highest FM frequency and store all station signals in sequence of
channel number. Short pressing this button to stop searching during the auto-scan.
6. NEXT/VOL+ : During USB/SD playback, short press this button to select next song, long press to reduce
input source volume. During Radio Channel mode, short press to move to next pre-memorized station
channel number, long press to increase volume.
OTHER CONTROLS OR CONTROLS ON BACK SIDE OF THE UNIT
1. Red LED (DC 5V): This indicates when battery is charging.
2. Blue LED (DC 5V ) This Blue LED is flashing when the blue-connect is ready for connect
3. 3.5mm Socket (LINE-IN): This is for connection of external audio input source.
4. Main Volume Knob (VOL): Turn to increase or decrease of master speaker volume.
5. ON/OFF/LIGHT Switch (ON/OFF/LIGHT): This is the master power switch for the device. Decorating
LED lights will turn on only if this switch is turn to LIGHT position.
6. DC-5V socket (DC-5.0V): This is for the 5 Volt DC input power source both for playback and/or charging.
You can connect through the USB charging cable provided with this package and connect to the AC to
USB Adaptor or to your computer's USB port to charge this device.
7. Retractable antenna: For better FM Radio reception, please pull out and extend fully while receiving radio
signal.
:
8. This battery logo on the LED display indicates the speaker is enough in battery.When it is flashing, It
indicates the speaker battery is low.It is a normal situation when the speaker playing is been cut down or
restart.
P-3