Idiomas disponibles
Idiomas disponibles
9
- L = 70mm, 460mm, 80mm to top track
B
L = 70mm, 465mm, 65mm to bottom of back panel
4 = to right hand edge of back panel
ADJUSTING THE BACK PANEL
10
- If the back panel is not correctly aligned with the side panels,
make the necessary adjustment by way of the top grip assembly.
ADJUSTING THE DOOR
11
- If the door is not correctly aligned with the side panels, make the
necessary adjustment by way of the top grip assembly.
FITTING THE ROOF
12
- Position the roof on the top track, making certain that the hoses
and electrical cables drop behind the back panel.
- E04 M - E04 M CR -
13
- Hot water connection.
- Cold water connection.
5 - Showerhead connection.
E04 L - E04 L CR -
-
- Hot water connection.
- Cold water connection.
1,2 - Descaler liquid connections.
3
- Sauna drain connection.
4,6 - Vaporizer connections.
5
- Showerhead connection.
7,8 - Upper and lower jet connections.
9
- Hand-held shower connection.
10 - Cold water connection.
11 - Mixed water connection.
12 - Emergency valve connection.
E04 L - E04 L CR -
-
- Cable for connection to a.c. supply.
T
- Cable for connection to alarm system
(only if bathroom is equipped with alarm system).
Aux - Audio input cable.
2
- Control panel connection.
4
- Connection of cable running from roof to power unit.
6
- Connection between power unit and temperature sensor.
12 - Connection of cable running from power unit to roof.
V
- Connections between power unit and fans.
- EQUIPOTENTIAL EARTH CONNECTION
Connect the earth wire from the roof to the top binding post
(
) and wire this post to the main earth node for the
bathroom; connect the earth wire from the back panel to the
bottom post (
Plumbing connections
Plumbing connections
Electrical connections
).
CHECKING THE PLUMBING AND ELECTRICAL
CONNECTIONS
Having made all the connections, start up the system as
described in the accompanying user manual.
Check that there are no leaks at the fittings and that everything
works as it should.
SECURING THE BACK PANEL
14
- Secure the back panel to the shower base and to the top track
with the clamp parts removed previously. Snap the concealers onto
the screws.
FITTING THE ACCESSORY RAIL
-
15
Fit the accessory rail, locating the ends on the pin of the
shower base and in the hole at the top of the side panel.
Secure the top of the rail to the wall bracket with nuts and
washers.
If the rail does not coincide with the plate fitted to the
wall bracket, make the necessary adjustments as in figures
15A and 15B.
ADJUSTING THE SPACER
-
16
Position the rubber stop close to the back panel.
Tighten the nut as illustrated.
FITTING THE WALL TRIMS
-
17
Prepare the wall trims, loosening the bolts (1).
A
Lift the fixing plates (2).
To inspect the equipment pack, detach the trim before
removing the back panel.
-
17
Hook the bottom ends (1) of the trims over the pins of the
B
shower base, and secure the top ends (2) to the wall
bracket with the screws and washers.
-
17
Tighten the bolts loosened previously.
C
SEALANT
-
18
Apply NEUTRAL SILICONE (NON-ACETIC) along the join
between the shower base and the floor so that water
cannot get in.
31
