IMG STAGELINE DMX-1TEST Manual De Instrucciones página 11

5.6 6. BACKLIGHT MODE
Via this item it is possible to adjust if the back-
ground illumination is to remain switched on
permanently or during the operation only.
1) Press the button ENTER (7).
2) Select with the button MODE (4):
ON: the illumination remains perma-
nently switched on
OFF: the illumination is switched off ap-
prox. 20 s after the last button is
pressed and switched on again
when a button is pressed again
(recommended for operation with
rechargeable batteries)
3) With the button MENU (3) cancel the selec-
tion or confirm with ENTER (the flashing
SETTING SAVE shows that the setting is
being saved).
5.7 7. POWER MANAGER
Via this menu item the operating time is adjus t -
ed after which the unit is switched to the energy
saving mode. In this mode the display is
switched off and, if required, the output of a
DMX signal is stopped. The LEDs DMX IN (2)
and DMX OUT (6) shortly flash in intervals.
The energy saving mode can only be exited
by pressing the button ENTER.
1) Press the button ENTER (7). The display
shows SLEEPING TIME and the currently
selected time after which the unit is switched
to the energy saving mode, measured from
switching on or from exiting the energy sav-
ing mode the last time.
2) Select a new value (1 to 10 minutes) with the
buttons LEVEL RANGE (8). With the setting
"0 minutes" the unit is never switched to the
energy saving mode.
3) Cancel the selection with the button MENU
(3) or confirm with ENTER (the flashing
SETTING SAVE shows that the setting is
being saved).
All rights reserved by MONACOR
may be reproduced in any form or by any means for any commercial use.
5.8 8. UNIT DISPLAY
This item allows to select in which format the
DMX values are displayed for the DMX output
(functions DMX OUT and AUTO FADE) and as
a presetting for the function DMX IN.
1) Press the button ENTER (7). The display
2) Select one of the following possibilities with
3) Cancel the selection with the button MENU
After operation switch off the unit with the
switch POWER. If it is not used for a longer pe-
riod of time, disconnect the plug-in power sup-
ply unit from the mains socket because even
with the DMX-1TEST switched off it has a low
current consumption.
6 Specifications
Power supply: . . . . . . . . . . 9 – 12 V
DMX connections: . . . . . . XLR, 3-pole
DMX address range: . . . . 512 channels
Dimensions: . . . . . . . . . . . 141 × 58 × 105 mm
Weight:. . . . . . . . . . . . . . . 700 g
Subject to technical modification.
® INTERNATIONAL GmbH & Co. KG. No part of this instruction manual
shows UNIT TYPE IS and the currently se-
lected display format.
the button MODE (4):
1. 000 – 255 decimal
2. 00H – FFH hexadecimal
3. 0 – 100% per cent
(3) or confirm with ENTER (the flashing
SETTING SAVE shows that the setting is
being saved).
supplied plug-in power
supply unit connected to
120 V – 240 V~/
50 – 60 Hz/10 VA
or 4 × 1.2 V rech. batt.,
type: NiMH, size: AA
GB
/300 mA via the
11