camry CR 7030 Manual De Uso página 4

15. Do not immerse the motor unit in water.
wet hands.
16. For household use only.
17. Do not use the vacuum cleaner to pick up flammable items (such as fuel, solvents).
18. Do not vacuum objects with sharp edges (e.g. broken glass).
19. Do not aim the vacuum cleaner toward other people or animals.
20. The vacuum cleaner may be used only on dry surfaces.
21. Use extra care when vacuuming stairs.
22. Do not block any vents.
23. Do not operate the vacuum cleaner without the filter. Use only original accesories.
24. Do not pull the vacuum cleaner by the hose or power cord
25. Make sure that the power cord is not wedged by a door and does not get jammed.
When moving the vacuum cleaner please note the length of the power cord. Pulling the
vacuum cleaner suddenly when the cord is taut may damage it.
26. Before vacuum vag,wait until the fire goes out and the hearth to cool down below 50
degrees.
DEVICE DESCRIPTION
1 Carrying handle
3 Lid
5 Clamp lock location
7 Vacuum tank
9 Suction wand
USING THE VACUUM
Prior to starting vacuuming, do the following:
– Open the cover (3) by releasing the cover clamps (6).
– Remove all the accessories from the tank (7).
– Insert the filter (10).
– Place the motor housing (2) on the vacuum tank (7).
– Snap the fastening clamps (6) in place (5) on the motor housing. After closing the clamps you will feel some slack – this is consistent
with the vacuum cleaner design. During the vacuum cleaner operation the motor housing will be firmly fixed to the tank. Any attempt to
close the clamp in a different position will result in breaking it and causing irreversible damage.
– Insert the wider end of the suction hose (8) into the air intake opening on vacuum tank (7).
– Attach the suction wands (9) to the other end of the hose.
– Turn the vacuum on with the on/off switch (2).
– If during the vacuuming the vacuum tank is fully , stop vacuuming and empty the tank (7).
CLEANING AND MAINTENANCE
– Turn off the vacuum and unplug the power cord.
– Disconnect the suction hose and suction wand.
– Open the clamps and take off the motor housing.
– Wash the tank (7).
– Remove the sponge filter (10) shake and wash under running water.
– Assemble the vacuum cleaner.
TECHNICAL DATA
Power supply: 220-240V~50Hz
Nominal power: 1200W Max: 2000W
To protect your environment: please separate carton boxes and plastic bags and dispose them in corresponding
waste bins. Used appliance should be delivered to the dedicated collecting points due to hazarsous
components, which may effect the environment. Do not dispose this appliance in the common waste bin.
Do not handle the appliance or power cord with
2 Motor housing
4 ON/OFF swich
6 Fastening clamps
8 Suction hose
10 Filter
4