Idiomas disponibles
Idiomas disponibles
Technical specifications
Model No.
TS206806
Voltage
220-240V~50/60Hz
Rated power
650W
No-load speed
800-2800/min
Cutting capacity:Wood
80mm
Steel
8mm
Angular cutting range
0±45°
TS206806-4
Model No.
(IRAM Plug)
Voltage
Rated power
No-load speed
Cutting capacity:Wood
Steel
Angular cutting range
TS206806-9
Model No.
(INMENTRO Plug)
Voltage
Rated power
No-load speed
Cutting capacity:Wood
Steel
Angular cutting range
OPERATION
Fitting The Saw Blade(see Dia 2)
When changing blades, set
pendulum action switch to "0"
To open the blade holder, rotate the ring
anti-clockwise (jig saw upside down) and hold in
position. Then fully insert the blade into the
blade holder slot with blade teeth facing forward
and release the ring, which will self rotate and
clamp over the top of the blade. Push the blade
into the blade holder again to ensure it is locked
in position. Ensure the edge of the blade is
located in the groove of the support roller. To
remove blade, hold the blade and rotate the
ring anti-clockwise then lift out the blade.
Warning:
Blade teeth are very sharp.
Blade self-eject out swiftly. Do not point
at people
Note: Remove clear blade gurad to
ease the fitting/removing of blades.
UTS206806
110-120V~50/60Hz
650W
800-2800/min
3-1/8˝
5/16˝
0±45°
TS206806-6
TS20
6806-8
(ISRAEL Plug)
(BS
Plug)
220-240V~50/60Hz
650W
800-2800/min
80mm
8mm
0±45°
TS206806S
(SAA Plug)
220-240V~50/60Hz
650W
800-2800/min
80mm
8mm
0±45°
Using the parallel guide(see Dis 3)
The parallel guide allows you to make an
accurate parallel cuts using the metric scale.
Put parallel guide into the required position
Slide the parallel guide in from the appropriate
side(left or right) accordingly.Make sure that
the guide surface of the parallel guide points
downwards.
Operating the Trigger Switch (see Dia 4)
To operate the Pendulum jig saw, depress
the trigger switch.If you wish to use the
Pendulum Jig saw continuously, the trigger
lock button can be pushed in after the trigger
switch has been depressed. To release the lock
button push in the trigger switch again.
Pendulum Action Switch Adjustment
(see Dia 5)
The saw blade pendulum action, adjustable in
four steps, makes possible the optimum
adaptation of saw advancing(cutting speed),
cutting performance and cut appearance of the
material. For each downward movement, the
saw blade is lifted off the material which
facilitates sawdust ejection, reduces heat
generated by friction and increases the service
life of the saw blade. At the same time the
reduction of the necessary advancing force
makes fatigue-free working possible. The
pendulum action switch makes possible the
adjustment of the pendulum action in four steps.
The switching can take place with the machine
running:
7
