Idiomas disponibles
Idiomas disponibles
C
③ x 4
ready to assemble. To avoid causing damages to the thread, DO NOT over-tighten the nuts or bolts.
1. Unpack the unit and confirm that you have all the hardware and required parts listed. Assemble the unit
on a carpeted floor or the empty carton to avoid any scratch.
2. Position one Seat (B) upside down on a level and protective surface.
3. Remove the plastic caps from the hanger bolts of the Front Legs (C). Attach 2 Front Legs (C) to the
front corner blocks of the Seat Frame (B) by inserting the pre-attached hanger bolts through the drilled
holes on corner blocks, and fit the Flat Washer (5), Lock Washer (4) and Hex Nut (3) onto each hanger
bolt. Tighten the hex nuts with the provided open wrench.
NOTE: DO NOT fully tighten all the nuts until the chair has been adjusted and all the legs are levelled so
that they do not wobble. Once adjusted then go back and tighten while making sure that the unit remains level.
Assembly Instructions
C
B
④ x 4
DO NOT fully tighten the bolts or nuts initially until all the bolts or nuts are
5
4
3
4
C
Pre-attached
C
B
⑤ x 4
