Idiomas disponibles
Idiomas disponibles
- lock the switch.
- turn wheel C to select maximum speed.
Changing direction of rotation (Fig.8).
- when not properly set in left/right position, switch A
cannot be activated.
Change direction of rotation only when tool is at a
complete standstill.
Normal drilling/screwdriving versus impact drilling
(Fig.9).
Select drilling function only when tool is switched
off and plug is disconnected.
Changing bits (Fig.10).
- insert the bit as deep as possible in the chuck.
Do not use bits with a damaged shank.
Adjusting drilling depth (Fig.11).
Holding and guiding the tool (Fig.12).
While working, always hold the tool at the black
coloured grip area(s).
- always use auxiliary handle F(Fig.2) (can be adjusted
as illustrated).
- keep the ventilation slots uncovered.
- do not apply too much pressure on the tool; let the tool
do the work for you.
7. APPLICATION ADVICE
Use the appropriate bits (Fig.13).
Only use sharp bits.
For drilling in concrete or stone, a steady pressure on
the drill is required.
When drilling ferrous metals.
- pre-drill a smaller hole, when a large hole is required.
- lubricate drill bit occasionally with oil.
When turning in a screw at/near the cross cut end or
an edge of wood, pre-drill a hole in order to avoid
cracking of the wood.
Splinter-free drilling in wood (Fig.14).
Dust-free drilling in walls (Fig.15).
Dust-free drilling in ceilings (Fig.16).
Drilling in tiles without skidding (Fig.17).
8. MAINTENANCE
Always keep tool and cord clean (especially the
ventilation slots).
Disconnect the plug before cleaning.
If the tool should fail despite the care taken in
manufacturing and testing procedures, repair should
be carried out by a qualified person (qualified
electrician).
GB
9. TROUBLESHOOTING
Problem
Possible cause
No electricity comes
to the machine.
Motor does
not run
The motor is
overloaded or
overheated.
The carbon brushes
are used.
Screws or parts of
the machine are
loose.
Vibrations are
The grinder is not
too strong.
correctly mounted.
Workpiece is not
properly supported.
10. DISPOSAL
Disposal of the appliance
A crossed-out wheelie bin icon means: Batteries and
rechargeable batteries, electrical or electronic devices must
not be disposed of with household waste. They may contain
substances that are harmful to the environment and human
health.
Consumers must dispose of waste electrical devices, spent
portable batteries and rechargeable batteries separately
from household waste at an official collection point to
ensure that these items are processed correctly. Information
on returning these items is available from the seller. Sellers
are required to accept these items free of charge. Batteries
and rechargeable batteries, which are not permanently
installed in waste electrical devices, must be removed prior
to disposal and must be disposed of separately. Lithium
batteries and battery packs in all systems must only be
returned to a collection point when discharged. Batteries
must always be protected against short circuits by covering
the poles with adhesive tape. All end users are responsible
for deleting any personal data stored on waste devices prior
to their disposal.
Disposal of the packaging
he packaging consists of cardboard and correspondingly
marked plastics that can be recycled. Make these materials
available for recycling.
11
Solutions
Check the power
supply and the
power line.
Allow the machine to
run idle for about 2
minutes so that it
can cool down.
Change out both
carbon brushes.
Tighten all screws.
Mount the grinder
correctly (Installing
the tool).
Secure the workpiece
(i. e. on a workbench).
