Loose Parts - Toro Flex-Force Power System 60V Manual De Instrucciones

Setup

Loose Parts

Use the chart below to verify that all parts have been shipped.
Procedure
1
2
Important:
The battery pack is not fully charged when you purchase it. Before using the tool for the
first time, refer to Charging the Battery Pack (page
1
Unfolding the Handle
Parts needed for this procedure:
1 Allen wrench
Procedure
1. Unfold the handle (A of
2. Align the locking button on the lower shaft with the slotted hole on the upper shaft and slide the 2 shafts
together (B and C of
Note:
The locking button clicks into the slotted hole when the shafts are secured (D of
3. Using the provided Allen wrench, tighten the screw on the shaft connector until it is secure (E of
Description
Allen wrench
Auxiliary handle assembly
Edger adjustment tool
Figure 3).
Figure 3).
Qty.
1 Unfold the handle.
1
Install the auxiliary handle.
1
14).
8
Use
Figure 3).
Figure 3).