Powerworks PD24CS Manual Del Operario página 3

1 DESCRIPTION
1.1 PURPOSE
The machine is used to cut all types of wood.
1.2 OVERVIEW
Figure 1.
Switch trigger
1
Lock-off Button
2
Spindle lock button
3
Hex key
4
Depth adjustment
5
lever
Bevel adjustment
6
knob
1.3 PACKING LIST
1 Circular saw
2 Hex key
3 Cutting blade
4 Edge guide
5 Dust tube with a screw
2 GENERAL POWER TOOL
SAFETY WARNINGS
WARNING
Read all safety warnings and all instructions. Failure to
follow the warnings and instructions may result in electric
shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
The term "power tool" in the warnings refers to your mains-
operated (corded) power tool or battery-operated (cordless)
power tool.
3 INSTALLATION
3.1 UNPACK THE MACHINE
WARNING
Make sure that you correctly assemble the machine before
use.
WARNING
• If parts of the machine are damaged, do not use the
machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, contact the service
center.
English
Edge guide
7
Width adjustment
8
knob
Lower guard
9
10 Base
11 Lower guard lever
12 Tube
6 Manual ( operation
manual, safety
instruction manual,
figure sheet )
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with local
regulations.
3.2 INSTALL THE BATTERY PACK
Figure 2.
WARNING
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the motor stops before
you install or remove the battery pack.
• Read, know, and follow the instructions in the battery
and charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
3.3 REMOVE THE BATTERY PACK
Figure 2.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
3.4 INSTALL THE BLADE
Figure 3.
Before you install the blade, remove the battery pack from
the machine.
1. Use the lower guard lever to lift the lower guard and hold
the lever.
2. Install the new blade.
3. Put the outer flange and the blade bolt on the spindle.
4. Push the spindle lock button to lock the spindle.
5. Use the hex key to tighten the bolt clockwise.
The arrow on the blade points the same direction as the
arrow on the top guard.
3.5 REMOVE THE BLADE
Figure 4.
5
NOTE
NOTE
EN