Lumatek LUMBC004 Manual página 5

If your ballast is not being controlled by an external Lumatek digital controller
please refer to the following table to decode flashing signal;
CONDITION
BALLAST LOCKED
CYCLE ERROR
LOW MAINS
OVER TEMPERATURE
HIGH MAINS
WARNING! When replacing a lamp, always switch off ballast first by removing plug from power supply.
NEVER SWITCH OFF LAMP BY REMOVING LAMP CABLE FROM A LIVE BALLAST.
HOT RE-STRIKE OF LAMPS. It is very important that the lamp is given adequate time to cool down before it is
re-ignited (10 min). Hot re-strike causes premature lamp failure and lumen output degradation. Additionally,
the lamp should never be turned off before it has reached full intensity. In the event of a power surge or
interruption causing the ballast safety system to switch off, to protect lamp and ballast, the Auto-start facility
will monitor when the lamp can be reignited.
The Lumatek ballast is tested for EMI (electro-magnetic radiation) and has met the highest standards. To help
prevent against EMI, mount ballast as close as possible to the reflector but not in the lamp's direct light (avoid
unnecessary heat).The shorter the lead to the lamp, the less chance of EMI. Do not coil excess wiring, particu-
larly the lamp lead. Keep mains lead and lamp lead separated to avoid potential interference signals.
The Lumatek ballast is silent with no noisy fan required and a graduated fin design case to help dissipate heat.
There is no serviceable parts inside as the electronics are sealed in a resin and opening the case will invalidate
the warranty.
5. WARRANTY
5 YEAR MANUFACTURER WARRANTY Lumatek warrants its Electronic ballast to be free from defects in materials
and workmanship. The warranty term is 3-years full + 2 years pro-rated beginning on the date of purchase.
Misuse, abuse, or failure to follow instructions, are not covered. Any changes or adaptations to the product of
any kind will void the warranty.
Lumatek will, at our option, repair or replace products covered under this limited warranty. To request warranty
service, you must return the unit with your proof of purchase to your place of purchase, within the warranty
period.
If warranty service is required, Lumatek's distribution partner will issue a Return Material Authorization Number.
Lumatek will ship the repaired or replacement products to you freight prepaid. Purchase date is based on the
original sales receipt. Please save your receipt as a copy is required for all warranty services.
6. LEGAL
CONFORMS TO CE TEST STANDARDS:
LVD
EN 61347-2-12:2005+A1:2010
EN 61347-1:2008+A1:2011+A2:2013
EN 62493:2015
For more information on Lumatek Electronic Ballasts please visit www.lumatek-lighting.com
All manuals and user guides at all-guides.com
LED STATUS
FLASH*1 Maximum number of ignition attempts witouth success
FLASH*2
FLASH*3
FLASH*4 Maximum driver temperature exceeded
FLASH*5
EMC
EN 55015:2013
EN61547:2009
EN61000-3-2:2014
EN61000-3-3:2013
DESCRIPTION
Lamp stopped for unknown reason
Mains voltage too low
Mains voltage too high