Idiomas disponibles
Idiomas disponibles
5. Always place the fan heater on a flat and even surface, it should not be exposed to vibration or
mechanical stress.
6. The appliance must be placed at a minimum distance of 50 cm from any combustible materials
as furniture, pillows, bedding, paper, clothes, curtains, plants, etc.
7. In order to have a good air aspiration and to avoid damaging of the product, maintain the air inlet
and outlet free from objects.
8. The appliance has dangerous components that must be kept out of the reach of children.
9. Never connect the power cord to extensions or triple plugs. Do not pull or damage the power
cord. Before any maintenance operations, disconnect the plug from the mains socket.
10. The power cord must never be in contact with the hot surfaces of the appliance.
11. Do not lay the power cord under a carpet. Do not cover the power cord with a cover or similar
elements. Pay attention not to place the power cable where it is likely to get into people's way.
12. If the appliance does not work properly, immediately turn it off and disconnect it from the mains
socket. For repairs, contact a technical support center authorized by the manufacturer, and
require that original spare parts be used. Using parts that do not conform to the product may
seriously compromise its correct operation.
13. In order to unplug the appliance, select "0" and disconnect the plug from the power socket.
INSTRUCTIONS FOR USE
1
Thermostat Knob
2
Power knob
3
Air outlet
4
Base
The fan heater features a top panel with knobs to select the different functions:
Power Knob
Thermostat knob
During operation the fan heater must be at a minimum distance of 50 cm from walls or other objects.
Direct the air flow towards such a point so that room heating is optimised. Do not direct the heat flow
towards corners or reduced spaces, or towards the floor or ceiling.
1. The fan heater is equipped with two levels of heating power: to have the minimum power, turn the
power knob to position "I" and to have the maximum power turn it to position "II".
2. To heat a room quickly, set the fan heater to its maximum position (activate both power buttons).
Once the room has reached an agreeable temperature, set the fan heater to a lower position in
order to reduce consumption and to prevent the room from getting too hot.
3. Select low or maximum heat emission; set the desired temperature through the thermostat. By
means of the thermostat it is possible to adjust the temperature gradually. Once the desired
temperature has been reached, the appliance turns off automatically. When the temperature falls
below the set level, the fan heater is activated again.
DT Istr (CM-1500)_02/20_Rev.0_02/20
"0"
OFF
Fan function: cold air flow
"I"
Heating function at minimum power
"II"
Heating function at maximum power
Auto swing function
The fan heater is equipped with a thermostat for
temperature adjustment. When the desired ambient
temperature is reached turn the knob counterclockwise
until the appliance turns off. It's noticeable by the "click"
sound of the thermostat
CM-1500
12/24
