Idiomas disponibles
Idiomas disponibles
Start up
Place the appliance on an even surface.Insert the mains plug into the socket.
Water supply
For connection values, see type plate.
ATTENTION
Impurities in the water can damage the high-pressure pump and accessories.
Water supply from mains.
Drawing in water from the open reservoirs.
This high-pressure cleaner works with the suction hose and backflow valve to draw in
surface water. For example, from water butts or ponds.
Fill the suction hose with water.
Screw the suction hose into the water connection of the appliance, then insert it into
the water source (e.g. rainwater drum).
Before use, bleed the device as follows:
● Turn on the switch '0/1'
● Unlock the lever of the trigger gun.
● Push the lever of the trigger gun, the device will switch on.
● Let the device run (maximum two minutes) until the water exits the trigger gun
without bubbles.
● Release the lever of the trigger gun.
● Lock the lever of the trigger gun.
Operation
ATTENTION
Dry running of more than two minutes can damage the high-pressure pump. If the
appliance does not build up pressure within two minutes, switch the appliance off and
follow the 'Troubleshooting' chapter.
High pressure operation
CAUTION
Keep a distance of at least 30 cm when using the jet for cleaning painted surfaces to
avoid damage.
CAUTION
Make sure the on/off switch is set to 'OFF/ON' and insert the plug into a properly
installed socket.
ATTENTION
● The washer must be used on a secure and stable surface in a standing, upright
position.
Connect the product to power and water supply as described.
● Open the water supply
● Hold the spray gun with both hands.
● Direct the nozzle of the chosen accessory away from you and towards the surface.
9
