Idiomas disponibles
Idiomas disponibles
GARANT Safety hose reel
5. Installation
5.1. WALL OR CEILING MOUNTING
en
B
ü Choose wall plugs and screws matching the wall or ceiling.
1. Release the safety-locking mechanism on the Hose reel, remove the Hose reel from the retain-
ing clip.
2. Position bracket on smooth surface and mark two drilling positions.
3. Drill holes, screw bracket firmly onto mounting surface with suitable screws and wall plugs.
4. Insert the Hose reel from below into the retaining clip, and push down the safety-locking
mechanism.
6. Operation
6.1. PULLING OUT THE HOSE
C
1. Slowly pull the Hose out to the desired length.
» Take care to pull the Hose out in a straight line.
2. To stop the Hose, pull on the Hose again until the locking mechanism gives an audible click.
6.2. CONNECTING
1. Connect Hose reel to the compressed air supply. Connect a suitable pneumatic tool to the
pneumatic tool connection.
» Comply with the respective manufacturer's operating instructions.
» Note the hose's maximum working pressure.
2. Check that all connections are in order.
WARNING! Risk of injury from pressurised hose. Fully relieve hose reel of pressure
after every use. Do not store when pressurised.
6.3. REELING IN HOSE
D
1. To release fastening, slowly pull Hose until you no longer hear the locking mechanism's click-
ing sound.
» Hose slides back into casing at controlled speed.
2. Guide Hose while it is reeling in.
7. Maintenance
Interval
Before each use
Immediately
14
Maintenance work
Check hose, hose guide and external
components for visible signs of wear.
Check for leaks using soap or leak finder
spray.
Repair defects and damage or replace.
Use genuine spare parts only.
Instruction manual
Performed by
Trained person
Trained specialist for mechan-
ical work.
Contact Hoffmann Group cus-
tomer service.
