WOODLAND SCENICS ST14402 Manual De Instrucciones

Enlaces rápidos

Read through instructions before use.
• Loosen thumb screws on Handle and insert Bows (Fig. 1a).
• Press down on a Bow until it is level with top of Handle and the interior
spring is engaged. Hold in place and tighten thumb screw (Fig. 1). Repeat
with other Bow. Do NOT over tighten.
• Measure and cut a piece of Wire approx. 6" in length. Install Wire with
or without Collars (Collars are required for angled cuts). When installed,
Wire must be taut between Bows.
• Wrap ends of Wire several times around grooves in tops of Bows, and then
twist it back onto itself. Secure close to edge of Bows.
• If using Collars, slide onto Bows with thumb screws facing out and tighten
(Fig. 2 and 2a). Thread one end of Wire through small, center hole in
Collar, extending out of top hole approx. 1" (Fig. 3a). Twist excess Wire
tightly around long Wire section and secure as close to edge of Collar
as possible. Repeat with other end of Wire on opposite Collar (Fig. 3).
Tighten loose Wire by rotating Collar.
• Adjust Collar placement for angled cuts (Fig. 4 and 4a).
To Use: Connect Transformer to Handle and then plug in Transformer. Push
Yellow Button on Handle forward to heat Wire while cutting, release when
cut is complete. Wire will heat only when Yellow Button is fully engaged.
Wire cools when Yellow Button is released, even slightly. Make slow, steady
cuts. Unplug when not in use.
This item is not a Children's Product and is not intended for use by Children.
CAUTION: Some foam products such as polyurethane foam may emit toxic fumes when heated. Use in ventilated area. Use
transformer included with this package. Do not leave Hot Wire Foam Cutter on for an extended period of time. Transformer
may overheat. Do not touch Wire while Cutter is on. Wire may cause burns. Be careful when using Hot Wire Foam Cutter near
flammable material or in areas where explosive gases may be present. Do not apply to a single contact point for an extended
period - heat may be conducted to combustible materials that are not in sight. Allow Wire to cool before storing Hot Wire Foam
Cutter. Unplug Hot Wire Foam Cutter after use.
Woodland ScenicS
All manuals and user guides at all-guides.com
HOT WIRE FOAM CUTTER
INSTRUCTIONS
Made in China
®
PO Box 98, Linn Creek, MO 65052 • woodlandscenics.com
F3
©1998 O CO
Fig. 1
Fig. 1a
Fig. 2
Fig. 2a
Fig. 3
Fig. 3a
Fig. 4
Fig. 4a
loading

Resumen de contenidos para WOODLAND SCENICS ST14402

  • Página 1 - heat may be conducted to combustible materials that are not in sight. Allow Wire to cool before storing Hot Wire Foam Cutter. Unplug Hot Wire Foam Cutter after use. Made in China ©1998 O CO Woodland ScenicS ® PO Box 98, Linn Creek, MO 65052 • woodlandscenics.com...
  • Página 2 ángulo). Cuando se instala, cable debe wird, sogar etwas ab. Machen Sie die langsamen, stabilen Schnitte. estar tensa entre asas. Trennen Sie, wenn nicht verwendet. Woodland ScenicS ® PO Box 98, Linn Creek, MO 65052 • woodlandscenics.com...