Idiomas disponibles
Idiomas disponibles
Check if the image device (videomonitor / video printer / LCD TV / ...) supports the camera
resolutions (1080p @ 60Hz / 1920x1080 @ 60 fps).
6.
Connect an optical device (optional: endocupler / image splitter) with C screw to the video
camera head.
7.
With the equipment off, connect power cable to the electrical socket.
4.1 REVISION
Once the installation is complete and before turning on the PROCAM HD camera we recommend
to do the following controls:
•
Verify that the electrical circuit is connected to ground and in perfect condition and that the
connection to the equipment is done perfectly too.
•
Check that the fuse holder is installed and with the correct fuses in (2 x T2AL250V).
•
Make sure no water or liquid supplies, or gases or inflammable fumes in the environment
are near the equipment that can harm it.
•
The unit must be connected to de wall socket using the original cable supplied by ECLERIS
without using any adapters.
The equipment must be used only in places where the electrical installation complies with
local regulations.
If any abnormality is detected before turning on the equipment, please contact the technical
service of your local distributor or your nearest ECLERIS office before using it.
In this section there are detailed procedures to turning on and verifying the equipment f unctions.
We recommended following them after the installation.
Only medical, paramedical or health personnel should use this equipment.
Do not sterilize the device. For use in the operating room use a sterile sheath.
1. Press the power button in front of the PROCAM HD console. The LEDs of the PROCAM HD
camera will blink for few seconds and then they will turn off. It indicates that the PROCAM
HD camera head is being powered.
2. Verify that the video monitor is ON and in Video mode through its HDMI input.
3. Proceed with the white balance.
4. Adjust the picture on the monitor according to your preferences of Brightness, Contrast,
Saturation, Color, HUE, Gamma.
5. Once the procedure is over, turn the device off in order to maximize the system lifetime and
energy saving.
INMANUUML023 USER M./M.USO PROCAM HD BASIC V.2022.10 ENG/ESP US
5. OPERATION
USER MANUAL – PROCAM HD II
Página 8 de 30
