Siefken STURM LUFT Manual De Usuario página 17

Idiomas disponibles

Idiomas disponibles

SPECIFICATIONS
Model
Power
Air tank
Max. Working pressure
Working temperature
Net
Input current
INSTALLATION AND OPERATION
Your new air compressor can be used for operating paint, weed killer, and insecticide sprayers, air tools,
grease & caulking guns, sandblasters, in ation, etc., Although you should compare the air demands of the
tool agains this compressor 0.5SCFM output (at 90PSI). A tool with a higher air demand than this compressor
can produce may either not function, or not function well. It may also cause the compressor to run without
stopping for long periods of time, trying to maintain pressure moves up and down in the cylinder. On the
down stroke, air is drawn in through the inlet valve. Since the discharge valve remains closed, as the piston
goes up, the air in the cylinder is compressed. The valve prevents it from going back into the pump. Working
air is not immediately available. The pump continues to add air until the air receiver pressure builds to
above that required at the regulator.
START OR STOP OPERATION
Put the plug into the outlet(110V), then pull up the red button of pressure switch to start the machine. When
need to stop, push the red button of pressure switch and unloader valve will be open to discharge pressure air
from exhaust pipe to check valve.
INSTALLATION AND LOCATION
Locate the compressor in a clean ,dry and well- ventilated area, on a rm level surface. It should be located 30
to 45cm / 12 to 18 inches from a wall or any other obstruction that would interfere with the air ow. It is
equipped with heat dissipation ns that allow for proper cooling. Keep them and other parts free of dust or
dirt that could interfere with cooling. A clean compressor runs cooler and provides longer service. Do not
place anything on top of the compressor. Do not use lead-tin solder to join pipes and ttings. It can melt at the
temperatures of the compressor' air discharge and cause the piping to burst.
1 YEAR
L I M I T E D WA R R A N T Y
SSL023
1.5 HP
23 L
150 PSI
0 - 80ºC
16 Kg
110 V - 60 Hz
4
loading

Este manual también es adecuado para:

Ssl023