Idiomas disponibles
Idiomas disponibles
30
C
onnecting Drain Hose
Before connecting Drain Hose, check 1 the drain hose applicable to your model and
choose the correct instructions.
Pump Model
1
Insert the plastic holder into hole
in the back side toward the stand
pipe direction. Adjust the holder
by pressing both sides to push in.
2
Push the end part of the drain hose in the outlet of the drain
pump and secure the clamp onto the rigid part of the outlet.
3
Put the other end of the drain hose over the standpipe or
wash tub. To prevent the hose that is connected 2 to the
machine from hanging down, push the hose into the holder
to 3 secure it.
Caution
• The outlet should be placed 0.9~1.2m higher than the floor.
• To prevent siphon, the drain hose should not be extended
more than 50mm from the end of the hose guide.
• A sagging or kinked hose may cause malfunctions or poor
drainage.
Non-Pump Model
1
Before connecting
Ensure that the hose clip is set as indicated here.
2
Connect the Elbow Hose
Push the elbow hose toward the body of the washing machine.
1
Place the Drain Hose
To change the direction of the hose, pull out the elbow hose and
change the direction. Repeat Step 2.
Holes
Bottom
For Holder
Within 50mm
Hose
Guide
0.9~1.2m
Clip
