Idiomas disponibles
Idiomas disponibles
LOADING THE N52FN/N62FN
EYE PROTECTION which conforms to ANSI specifications and provides protection against
flying particles both from the FRONT and SIDE should ALWAYS be worn by the operator and
others in the work area when connecting to air supply, loading, operating or servicing this
tool. Eye protection is required to guard against flying fasteners and debris, which could
cause severe eye injury.
The employer and/or user must ensure that proper eye protection is worn. Eye
protection equipment must conform to the requirements of the American National
Standards Institute, ANSI Z87.1 and provide both frontal and side protection.
NOTE: Non-side shielded spectacles and face shields alone do not provide adequate
protection.
TO PREVENT ACCIDENTAL INJURIES:
• Never place a hand or any other part of the body in nail discharge area of tool
while the air supply is connected.
• Never point the tool at anyone else.
• Never engage in horseplay.
• Never pull the trigger unless nose is directed at the work.
• Always handle the tool with care.
• Do not pull the trigger or depress the trip mechanism while loading the tool.
1. Loading Nails
Insert strip of nails into rear
of magazine
2. Engaging Pusher
Pull pusher guide to the rear of tool to engage
pusher to strip of nails
Note: Do not touch pusher tab while pulling
pusher guide to the rear of tool
ADJUSTING THE MULTI-DIRECTIONAL EXHAUST
To adjust the multi-directional exhaust simply rotate the exhaust deflector in a
desired position as illustrated arrows 1 & 2
Pusher Guide
-6-
nail stop
3. Removing Fasteners
Depress the pusher tab slightly to disengage
from the nails and slowly slide pusher forward to
the nose piece. Replace fasteners. Pull pusher
guide to rear of tool and re-engage fasteners
Location for loading
strips of nails
Pusher Guide
1
2
