Idiomas disponibles
Idiomas disponibles
BASIC SHREDDING OPERATION
Continuous operation:
Up to 15 minutes maximum
NOTE: Shredder runs briefly
after each pass to clear entry.
Continuous operation beyond
15-minutes will trigger
30-minute cool down period.
PRODUCT MAINTENANCE
OILING SHREDDER
performance. If not oiled, a machine may
experience diminished sheet capacity, intrusive
noise when shredding and could ultimately
recommend you oil your shredder each time
you empty your waste bin.
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
TROUBLESHOOTING
PAPER JAM
1
2
If Remove Paper icon
automatically reverse
(
) is illuminated,
the paper out
there is too much paper
for the shredder to shred
LIMITED PRODUCT WARRANTY
in material and workmanship and provides service and support for 1 year from the date of purchase
by the original consumer. Fellowes warrants the cutting blades of the machine to be free from
defects in material and workmanship for 1 year from the date of purchase by the original consumer.
If any part is found to be defective during the warranty period, your sole and exclusive remedy will
not apply in cases of abuse, mishandling, failure to comply with product usage standards, shredder
operation using an improper power supply (other than listed on the label), or unauthorized repair.
Fellowes reserves the right to charge the consumers for any additional costs incurred by Fellowes to
PAPER/CARD
1
2
Set to Auto-On ( )
Plug in and put
disconnect power
CD
1 1
2
Set to Auto-On ( )
Plug in and put
disconnect power
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1
Set to Auto-On ( )
3
Remove all uncut
paper from entry
3
Feed into paper/card
straight into paper entry
and release
3
4
Hold CD at edge
2
3
Set to Reverse (
* Apply oil
2-3 seconds
across entry
4
5
) and Reverse
(
) until jam is cleared
provide parts or services outside of the country where the shredder is initially sold by an authorized
conditions of this warranty are valid worldwide, except where different limitations, restrictions, or
please contact us or your dealer.
Feed into center of
CD entry and release
)
Shredder doesn't start:
Make sure bin is pushed in
Make sure Power Button is on (green)
Wait 30 minutes for motor to cool down
Empty Bin
3
